LVA4.150 (Amplificador clase D de 4 canales 1 unidad de rack)

Amplificador clase D de 4 canales con 1 unidad de rack.

Potencia: 4×130 W RMS en 4 ohmios.

Conexiones Euroblock.

Control de volumen en el panel frontal.

Peso 21kg;

    Consultar precios

    También te recomendamos…

    Descripción

    Amplificador clase D de 4 canales con 1 unidad de rack.

    Potencia: 4×130 W RMS en 4 ohmios.

    Conexiones Euroblock.

    Control de volumen en el panel frontal.

    Peso 21kg;

     

    LVA4.150
    Power (Both channels driven) 360 W x 4 2Ω (EIAJ) – 150 W x 4 4Ω (RMS) – 90 W x 4 8Ω (RMS)
    Bridge Mono 720 W x 2 4Ω (EIAJ) – 300 W x 2 8Ω (RMS)
    Input Sensitivity (Limiter Off) 0.9 – 1.1V (+0/-1dBv)
    Input Impedance 20K ohms balanced or 10K ohms unbalanced
    Frequency Response 20Hz~20KHz (+0/-1dB) (At 10dB below Rated Output Power)
    Voltage Gain 28 (+/-0.5dB)
    THD + N <0.1% (1KHz 1/8 Rated Power, A-Weighted)
    S/N Ratio (Ref. 1KHz, A-Weighted) > 96dB
    Crosstalk (Below Rated Power) > 70dB
    Damping Factor (1KHz, 8W) > 200
    Power/Output Circuity Switching Power Class-D
    Protections Full short circuit, open circuit, thermal, ultrasonic, and RF protection stable into reactive or mismatched loads, turn ON/OFF, muting, tried crowbar
    Controls Front: On/Off Power Switch, Volume Channel A, B, C, D – Rear : 8 preset modes
    Indicators POWER: 1 blue – PROTECTION & CLIP: 4 red – SIGNAL: 4 green LEDs
    Connectors Inputs: Euro block – Outputs: Euro block
    Power Supply AC: 110-120V or 220~240V 50/60Hz
    Dimension (HxWxD) 44 x 483 x 360 mm / 1.73″ x 19.02″ x 14.17″
    Weight 4.6 kg / 10.14 lbs